Manitoba Fishing Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter · #1 ·
If anybody else is running a Finbore hand auger and looking for an extension. If you buy a Ion-x ice auger extension it will fit the auger if you widen the bottom hole on the hand crank piece with a 1/4" drill bit. Id say get the 1' model as the extension only allows the hand crank to go in until the first hole (because its made for the power auger with a short shaft) good luck out there
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top